Use this cable to connect a single axis stepper controller with a PMinMO compatible connector^ (Linistepper, SLAm, etc...) to its break out board. Note: When used with our 4Axis board, only two non-adjacent axis can be connected with this cable. E.g. X and Z or Y and A. This limitation is due to the spacing of the axis headers on the 4Axis board; which was required to support the use of a single 2x20 IDC cable which fans out to 4 separate 2x10 PMinMO drivers. If you need more than 2 axis, use the 4Axis cable instead.

length: 5 inches.
conductors: 10.
connector1: 2x5 female IDC.
connector2: 2x5 female IDC.
wire size: Ribbon.
level: easy.

You may also be interested in:
416079 PID Servo Controller: 
416012 break out board: 
416014 connect up to 4 axis with one cable: