please dont rip this site

MassMind : Applications : CAD : PWB CAD : OrCAD

OrCAD Tutorial by Vikas Shukla of ReferenceDesigner.com

This tutorial is intended for beginners in printed circuit board design who wish to design a schematic and layout a board using the OrCAD Tool. In this tutorial:

Schematic Capture Board Layout (work in progress)
  • Introduction
  • Design Objectives
  • General Navigation
  • Creating Footprints
  • Importing Netlists, placing components
  • Routing
  • Silkscreen
  • DRC: Design Rule Check
  • Gerber Generation

INTRODUCTION

Those who had experience with one or more Schematics Capture design tool may skip this page. Others may like to get a general view of the PCB design process, which is follows:

1. Select the components (capacitors, sockets, etc.) you will be using on your board. Once you have a list, collect the datasheets and look at the suggested schematics in those datasheets.

In actual practice following are the main categories of the components used

Resistors, Capacitors, Inductors, Ferrite Beads
Diodes, Transistors, FETS, LEDs
Connectors, Headers
ICs, BGA ICs
Others

2. For each component, you have to create a Symbol of the Component in the Library. Symbols is a physical view of the component that includes all the pins of the components and one or more properties. The component must have an associated footprint that will be used for Layout.

In practice, you will already have most of the libraries available and you should need to create only few additional symbol libraries for a new design. You will need to be careful to verify that the existing library in your design library matches the component according to its datasheet.

There are reference designs available from companies like freescale, Texas Instruments. You may get the Orcad Symbol from them.

3. To create a Schematics get the components on your Schematics and connecting them with wires. You will add the Power and Ground as necessary. If your design spans more that one page you will need to connect them with off page connector.

4. Check your Schematics for design errors. Generate a net list. The net list is used by the Layout tools for importing.

Also:

See also:


file: /Techref/app/orcad_01.htm, 3KB, , updated: 2009/9/29 10:50, local time: 2024/12/14 06:09,
TOP NEW HELP FIND: 
18.97.14.90:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://techref.massmind.org/Techref/app/orcad_01.htm"> OrCAD, Schematic capture, PCB CAD</A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to massmind.org!

 

Welcome to techref.massmind.org!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .