please dont rip this site

Flux for use in Soldering PCBs

Although not strictly required, flux really helps the soldering process by "wetting" or reducing the surface tension of the solder so it will flow easily into the joint. They can also chemically remove impurities and prevent the metal from oxidizing as it is heated by the iron. Some fluxes (non-acid or "R" type) will act as a protectant after the soldering is finished to reduce corrosion, but others (acid core aka "Activated" or "RMA" and especially "RA" types) actually etch the metal and will eat it away if not removed by cleaning with water or isopropyl alcohol. "No clean" fluxes are non-corrosive, and non-conductive, but may not perform as well and leave behind unsightly resedue which is usually still cleaned away.

Flux is probably most critical when soldering Surface Mount Devices, where it is applied by hand with a very fine dropper or pen, or as part of a solder paste which also contains tiny balls of solder. Solder paste can be applied manually, but is most often applied through a metal stencil or solder mask in a process much like silkscreen printing.

For standard electronics soldering, rosin (made from purified select pine tree sap) disolved in an evaporative base such as isopropyl alcohol has been the standard.

See also:


file: /Techref/solderflux.htm, 2KB, , updated: 2012/5/11 07:49, local time: 2024/12/2 15:16,
TOP NEW HELP FIND: 
18.97.14.89:LOG IN

 ©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions?
Please DO link to this page! Digg it! / MAKE!

<A HREF="http://techref.massmind.org/techref/solderflux.htm"> Flux for use in Soldering PCBs </A>

After you find an appropriate page, you are invited to your to this massmind site! (posts will be visible only to you before review) Just type a nice message (short messages are blocked as spam) in the box and press the Post button. (HTML welcomed, but not the <A tag: Instead, use the link box to link to another page. A tutorial is available Members can login to post directly, become page editors, and be credited for their posts.


Link? Put it here: 
if you want a response, please enter your email address: 
Attn spammers: All posts are reviewed before being made visible to anyone other than the poster.
Did you find what you needed?

 

Welcome to massmind.org!

 

Welcome to techref.massmind.org!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  .