CRC error detection computes the remainder of a polynomial division of a generator polynomial into a message. The remainder, which is usually 16 or 32 bits, is then appended to the message. When another remainder is computed, a nonzero value indicates an error. Depending on the generator polynomial's size, the process can fail in several ways, however. It is very difficult to determine how effective a given CRC will be at detecting errors.
The probability p that a completely random (bad) message will be incorrectly accepted as valid (not detected as a CRC error), is completely a function of the code rate: p = 2^{r} = 2^{(n  k)}. Where
Use of the CRC technique for error correction normally requires the ability to send retransmission requests back to the data source.
See also:
http://www.dalsemi.com/DocControl/PDFs/app27.pdf
Comments:
Oops, you are right. I hope it's fixed now. Thank you.
David A Cary Says:
16bit CRC routine (isochronous) for the polynomial 0x8005+
Scott Dattalo, Dave Dribin (20020824)
http://www.piclist.com/techref/postbot.asp?by=time&id=piclist\2002\08\24\233838a&tgt=post
A quick guide to CRC: With example calcuation of CRC 16 by Pierre Desrochers +
See also:
Code:
file: /Techref/method/error/crc.htm, 6KB, , updated: 2011/11/28 21:08, local time: 2018/7/16 20:50,

©2018 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://techref.massmind.org/techref/method/error/crc.htm"> Cyclic Redundancy Check error detection</A> 
Did you find what you needed? 
Welcome to massmind.org! 
Welcome to techref.massmind.org! 
.