When the "Low side" (3.3 volt device) is high, mosfet off, "High side" (5 volt device) is at 5 votls via R2. When low, mosfet on, grounding high side. When 5 volt device drives "High side" to 5 volts, mosfet source pulled up to 3.3 volts for low side. When low, mosfet is activated via substrate diode, grounding low side.
NEW! RLC-2 RS232 Level Converter in a DB9 backshell
The Art of Electronics (Horowitz & Hill, Cambridge University Press, ISBN 0-521-37095-7) On page 574 is a nice little table that lists what you can drive with what.
From To-> | TTL | HCT/ACT | HC/AC | 4000B/74C@5v |
TTL | OK | OK | 1 | 1 |
HCT/ACT | OK | OK | OK | OK |
HC/AC | OK | OK | OK | OK |
4000B/74C@5v | OK* | OK | OK | OK |
1 pullup to +5V, or use HCT as interface.
Archive:
See also:
file: /Techref/logic/levelconversion.htm, 2KB, , updated: 2020/2/29 20:19, local time: 2024/12/4 14:36,
18.97.14.83:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://techref.massmind.org/techref/logic/levelconversion.htm"> Logic Level Conversion</A> |
Did you find what you needed? |
Welcome to massmind.org! |
Welcome to techref.massmind.org! |
.