In general, the Linistepper will do best with low amperage, higher voltage motors. E.g. a 12 Volt, 1 Amp motor is better for the Lini than a 1 Volt, 12 Amp motor. Remember: only Unipolar (5 or more wires)!
Suggest a new motor for use with the Linistepper by filling out this form:
Laserjet II and III printers (not the IIIsi, 4, or higher)
Also:
Lin Engineering 5618L-54
Lin Engineering 5718M-15-09
Lin Engineering 4118L-07
Anaheim Automation 23L004S-LW8
Kysan 57BYG070
Kysan 57BYGH211
Salem Controls SC23-57BYGH803
ORM 264K-2
Vexta PK266-02A
XUQUAN 23H256-30-6B
Sanyo Denki^ 103H546-0440
Sanyo Denki 103H7126-0941 (as found in Toshiba photocopiers; models: 7550, 6560, 6560, 5540.)
Sanyo Denki 103H7126-1441 (as found in Xerox XDL33D photocopier )
Shinano SST42D1040
Shinano SST42D1041
Shinano SST42D1020
Shinano SST42D1021
Shinano SST42D2040
Shinano SST42D2041
Shinano SST42D2030
Shinano SST42D2031
| file: /Techref/io/stepper/linistep/motors.htm, 1KB, , updated: 2009/11/2 14:03, local time: 2010/7/31 15:44,
38.107.191.83:LOG IN
|
| ©2010 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? Please DO link to this page! Digg it! <A HREF="http://techref.massmind.org/techref/io/stepper/linistep/motors.htm"> Good Stepper Motors for the Linistepper</A> |
| Did you find what you needed? |
|
.