[Menu]>[Guide to use the PIC]


What is the PIC ?




The PIC was developed as a peripheral controller


PIC(Peripheral Interface Controller) is the IC which was developed to control peripheral devices, alleviating the load from the main CPU.
Compared to a human being, the brain is the main CPU and the PIC is equivalent to the autonomic nervous system.





The PIC is the small computer


The PIC, like the CPU, has calculation functions and memory, and is controlled by the software.
However, the throughput and the memory capacity are low. Depending on the kind of PIC, the maximum clock operating frequency is about 20 MHz and the memory capacity (to write the program) is about 1K to 4K words.
The clock frequency determines the speed at which a program is read and an instruction is executed. The throughput cannot be judged with the clock frequency alone. It changes with the processor architecture. However within the same architecture, the one with the highest clock frequency has the highest throughput.
I use a 14-bit WORD for program memory capacity. An instruction is a word long. Program memory is measured in BYTES, one byte is 8 bits. The bit is the smallest unit, and can have the value of 1 or 0. The instruction word of the PIC16F84A is composed of 14 bits. 1K words is equal to 1 x 1,024 x 14 = 14,336 bits. To convert this to bytes divide it by 8 x 1024, (14,336 / 8 x 1024 = 1.75K bytes).

A memory capacity of 1G bytes = 1,024M bytes, 1M bytes = 1,024K bytes, 1K bytes = 1,024 bytes. 1K bytes is not equal to 1000 bytes. This is because the calculation is in binary (2 to the tenth power = 1,024).




When using the PIC it is possible to make the circuitry compact

The PIC is convenient for making calculations. The memory, the input/output ports and so on are incorporated into the IC.
The efficiency and the functions are limited, but the PIC can do the job of many IC's with software. So, the circuit can be compact.