//////////////////////////////////////////////////////////////////////////////////////

#include <18F4550.h>

#device adc=8

#FUSES NOWDT                 	//No Watch Dog Timer
#FUSES WDT128                	//Watch Dog Timer uses 1:128 Postscale
#FUSES HSPLL                    //High speed Osc (> 4mhz)
#FUSES NOPROTECT             	//Code not protected from reading
#FUSES NOBROWNOUT              	//No Reset when brownout detected
#FUSES BORV20                	//Brownout reset at 2.0V
#FUSES NOPUT                 		//Power Up Timer
#FUSES NOCPD                 	//No EE protection
#FUSES STVREN                	//Stack full/underflow will cause reset
#FUSES DEBUG               		//Debug mode for ICD
#FUSES NOLVP                 	//No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O
#FUSES NOWRT                 	//Program memory not write protected
#FUSES NOWRTD                	//Data EEPROM not write protected
#FUSES IESO                  	//Internal External Switch Over mode enabled
#FUSES FCMEN                 	//Fail-safe clock monitor enabled
#FUSES NOPBADEN              	//PORTB pins are configured as digital I/O on RESET
#FUSES NOWRTC                	//configuration not registers write protected
#FUSES NOWRTB                	//Boot block not write protected
#FUSES NOEBTR                	//Memory not protected from table reads
#FUSES NOEBTRB               	//Boot block not protected from table reads
#FUSES NOCPB                 	//No Boot Block code protection
#FUSES MCLR                  	//Master Clear pin enabled
#FUSES LPT1OSC               	//Timer1 configured for low-power operation
#FUSES XINST                 	//Extended set extension and Indexed Addressing mode enabled
#FUSES PLL5                  	//Divide By 5(20MHz oscillator input)
#FUSES CPUDIV1               	//System Clock by 1
#FUSES USBDIV                	//USB clock source comes from PLL divide by 2
#FUSES VREGEN                	//USB voltage regulator enabled

#use delay(clock=48000000)