DRAWING CIRCLES The CI command uses your current pen position as the center of the circle; you specify the radius of the circle. For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] Esc] in DOS EDIT EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2. SP1; Selects pen number 1, (black). The SP command must be used to enable printing. PA2400,2500; Specifies absolute plotting and moves to position (2400,2500). CI500; Draws a circle with a radius of 500 plu (plotter units); the center of the circle is the current pen location (2400,2500). Ec%0A Enters the PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.
file: /Techref/language/pcl/lj1889.asc, 1KB, , updated: 1993/11/15 16:15, local time: 2024/12/4 14:25,
18.97.14.83:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://techref.massmind.org/Techref/language/pcl/lj1889.asc"> language pcl lj1889</A> |
Did you find what you needed? |
Welcome to massmind.org! |
Welcome to techref.massmind.org! |
.