So you've got your board's built, now you want to see your motors run! Here's a quick start guide to configuring Mach3 to run your linistepper boards.
4 Axis Kit Version 4 up:
Enable X axis w/green check in box
Enable Y axis w/green check in box
Enable Z axis w/green check in box |
4 Axis Kit Versions 1-3:
Enable X axis w/green check in box
Enable Y axis w/green check in box
Enable Z axis w/green check in box |
Direct connect to Stepper Driver e.g. Linistepper, SLAm, THB6064AH
Any configuration can be used |
Hope this quick start helps you configure your system! These setup directions are from hours of trial and error use at your own risk!
If you notice anything I missed or revision please email me {ed: or use the form at the bottom of the page to add your comments} and we will update.
Mach 3 also has a Yahoo users group you can join.
Thanks and enjoy! Feel free to share this information with others.
Brian gerber N3GUC@yahoo.com
See
file: /Techref/io/stepper/linistep/mach3.htm, 5KB, , updated: 2015/1/16 16:09, local time: 2024/10/8 14:18,
44.220.251.236:LOG IN ©2024 PLEASE DON'T RIP! THIS SITE CLOSES OCT 28, 2024 SO LONG AND THANKS FOR ALL THE FISH!
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://techref.massmind.org/Techref/io/stepper/linistep/mach3.htm"> Mach3 linistepper Quick Start</A> |
Did you find what you needed? |
Welcome to massmind.org! |
Welcome to techref.massmind.org! |
.